When many car owners use the air conditioner, they are accustomed to turning the air outlet of the air conditioner downward, which is not conducive to the cooling of the air conditioner. When cooling, it is best to blow the air conditioner upward, because the cold air will sink down, and the wind direction block is best to choose the side block, do not choose the block that blows the windshield, because the temperature of the windshield is very high, it will offset part of the cooling effect.

The temperature inside the car should not be adjusted too low

All car owners have such experiences. In summer, due to the frequent use of air conditioners, the fuel consumption is much larger than that in the spring and autumn. How to turn on the air conditioner in the hot summer to reduce fuel consumption? Expert advice: In addition to sticking a good explosion-proof film to the car, the following driving habits and skills can also help car owners save fuel.

Do not start the air conditioner immediately after exposure to the sun

In summer, the sun is strong, and the car is parked under the scorching sun for a while, and the temperature inside the car is as high as 60 to 70 degrees Celsius. At this time, you can first open the doors and windows, wait for the hot air to be discharged from the car, then sit in and start the car, turn on the external circulation of the air conditioner, and when the temperature inside and outside the car is similar, then close the windows and activate the internal circulation.

Adjust the air outlet of the air conditioner upwards

Don't turn down the air conditioner temperature too low when driving in summer. This will not only increase fuel consumption, but also affect your health. Generally, the temperature difference between the inside and outside of the car should be within 10 degrees Celsius. If you have a long or short constant temperature air conditioner, you can first set the cold temperature to the lowest temperature and the wind speed to the maximum. When you feel cold, increase the temperature a little bit, and reduce the wind speed by one block. If it is still cold, increase the temperature again, and then turn When the wind speed drops, repeating this is the accurate control.